Fit L4-1.5L (2008)
23. Install the dowel pins (A) and new O-ring (B) on the oil pump (C), then align the inner rotor with crankshaft, and install the oil pump.
24. Install the oil screen (D) with new gasket (E).
25. Install the cylinder head.
26. Install the cam chain.
27. M/T model: install the flywheel, clutch disc, and pressure plate.
28. A/T model: Install the drive plate.
29. Install the transmission:
^
Manual transmission.
^
Automatic transmission.
30. Install the engine assembly.
NOTE: Whenever any crankshaft or connecting rod bearing is replaced, it is necessary after reassembly to run the engine at idle speed until it
reaches normal operating temperature, then continue running it for about 15 minutes.