Fit L4-1.5L (2008)
6. Inspect the cover washer (B). Replace any washer that is damaged or deteriorated.
7. Tighten the bolts in three steps. In the final step tighten all bolts, in sequence, 12 Nm (1.2 kgf-m, 8.8 lbf-ft).
NOTE:
^
Wait at least 30 minutes to allow liquid gasket to cure before filling the engine with oil.
^
Do not run the engine for at least 3 hours after installing the head cover.
8. Install the harness bracket mounting bolt (A) and breather hose (B).
9. Install the four ignition coils.
10. Install the intake manifold.
11. Check that all tubes, hoses, and connectors are installed correctly.
