Fit L4-1.5L (2008)
^
If it is too high (closer to the valve stem), you must make a second cut with the 67.5° cutter (intake) or 60° cutter (exhaust) to move it down,
then one more cut with the 45° cutter to restore seat width.
^
If it is too low (close to the valve edge), you must make a second cut with the 30° cutter to move it up, then make one more cut with the 45°
cutter to restore seat width.
NOTE: The final cut should always be made with the 45° cutter.
8. Insert the intake and exhaust valves in the head, and measure valve stem installed height (A).
9. If valve stem installed height is over the service limit, replace the valve and recheck. If it is still over the service limit, replace the cylinder head;
the valve seat in the head is too deep.
