Fit L4-1.5L (2008)
Tire Pressure Sensor: Testing and Inspection
Tire Pressure Sensor Location
Tire Pressure Sensor Location
Special Tools Required
TPMS sensor initializer tool AKS0620006
Available through the American Honda Tool and Equipment Program; call 888-424-6857
NOTE: This procedure locates where the tire pressure sensors number 1, 2, 3, 4 are mounted. When activated by the TPMS sensor initializer. Sensors
1, 2, 3, 4 location will change in these cases:
^
Memorizing tire pressure sensor IDs (including replacing the TPMS control unit, or the tire pressure sensors).
^
Wheel rotation.
1. With the ignition switch OFF, connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the vehicle and the TPMS control unit. If it doesn't, troubleshoot the DLC circuit.
4. Select Function test from the mode menu, then select Sensor Position check on the HDS.
5. Follow the prompts on the HDS to active the tire pressure sensors using the TPMS sensor initializer tool. Start with the left-front (LF) wheel.
NOTE:
^
See the HDS Help menu for specific instructions.
^
Initialize the wheel in the sequence shown.
