honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Recall - SRS Floor Wiring Harness Corrosion|Page 6923 > < Recall - SRS Floor Wiring Harness Corrosion|Page 6921
Page 18
background image

6.

Turn the ignition switch to ON (II), and make sure the SRS indicator comes on and then goes off.

7.

Do the idle learn procedure:

^

Make sure all electrical items (A/C, audio unit, defogger, lights, etc.) are off.

^

Start the engine, and let it warm up to its normal operating temperature (the cooling fans cycle twice).

^

Let the engine idle (throttle closed and all electrical items off) for 10 minutes.

8.

Test-drive the vehicle, and make sure everything works properly. Also, make sure there are no rattles.

9.

Center-punch a completion mark above the third character of the engine compartment VIN.

10.

If not already completed, do Service Bulletin 07-011, Safety Improvement Campaign: Fit SRS Unit Reprogramming.*

Recall - SRS Floor Wiring Harness Corrosion|Page 6923 > < Recall - SRS Floor Wiring Harness Corrosion|Page 6921