Fit L4-1.5L (2008)
13.
Using electrical tape, wrap the seal 10 mm from the beginning of the seal to 10 mm past the end of it.
14.
Use the electrical tape to wrap the wire harness between the yellow clip and the harness branch fork.
15.
Install the wire harness back into the corrugated tube.
16.
Use the electrical tape to wrap the corrugated tube between the yellow clip and the harness branch fork. Make sure the slit in the tube is fully
covered with tape.
17.
Install a new strap clip to the harness, and cut off the scrap end of the strap.
18.
Reattach the yellow clip and the strap clip to the floor panel.