Fit L4-1.5L (2008)
13. Install the seat belt in the reverse order of removal, and note these items:
-
Apply medium strength type liquid thread lock to the upper anchor bolt before reinstallation.
-
Tighten the bolts by hand first, then tighten to the specified torque.
-
Check that the retractor locking mechanism functions.
-
Assemble the washer, collar, and bushing on the upper anchor bolt as shown.
-
If the threads on a retractor mounting self-tapping ET screw are worn out, use an oversized self-tapping ET screw, P/N 90133-SZ4-003, made
specifically for this application.
-
If the seat belt tensioner has been deployed, replace the B-pillar lower seal with a new one.
-
Before installing the anchor bolts, make sure there are no twists or kinks in the seat belt.
-
Make sure the seat belt tensioner connector is plugged in properly.
-
Reconnect the negative cable to the battery.
-
Enter the anti-theft codes for the audio system.
-
Set the clock.
-
Check for any DTCs that may have been set during repairs, and clear them.
Seat Belt Buckle
1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
2. Remove the front seat.
3. Remove the center cover from the seat.
4. Detach the seat belt switch connector (A).
