Fit L4-1.5L (2008)
^
If any of the terminals have corrosion, or if any of the connectors are melted, replace the driver's door wire harness, then get a power window
master switch kit, and go to step 13.
7. Remove the main switch button from the power window master switch body.
8. Using a small, flat-tip screwdriver, separate the two halves of the switch case:
^
Insert the screwdriver into the clip slots in the bottom edge of the switch case to release the eight clips in the order shown below (A, B, C, D, E,
F, G, and H).
^
Remove the bottom half of the switch case.