Fit L4-1.5L (2008)
15. Install the switch on the switch cover (three screws).
16. Reinstall the switch cover to the switch panel.
17. Connect the 3P and 20P connectors to the switch.
18. Reinstall the driver's door grip cover in the reverse order of removal. NOTE: When you reinstall the cover, insert the rear hook first, then work
forward to secure the remaining hooks.
19. Turn the ignition switch to ON (II).
20. Open the driver's window all the way. When the window reaches the bottom, hold the switch in the DOWN position for 2 seconds.
21. Close the driver's window all the way. When the window reaches the top, hold the switch in the UP position for 2 seconds.
22. Make sure the door lock switch works. If it doesn't, recheck your work.
23. Center-punch a completion mark above the fifth character of the engine compartment VIN:
Disclaimer
