Fit L4-1.5L (2008)
Clutch Disc: Testing and Inspection
Clutch Replacement
Special Tools Required
^
Clutch alignment shaft 07JAF-PM7012A
^
Ring gear holder 07LAB-PV00100 or 07924-PD20003
^
Driver 07749-0010000
^
Bearing remover shaft 07936-KC10500
^
Handle 07936-3710100
^
Attachment, 28 x 30 mm 07946-1870100
^
Slide hammer, 3/8"-16 commercially available
Pressure Plate and Clutch Disc Removal
1. Check the height of the diaphragm spring fingers using the dial indicator (A). If the height is more than the service limit, replace the pressure plate.
2. Install the clutch alignment shaft (A), handle (B), and the ring gear holder (C).
3. To prevent warping, unscrew the pressure plate mounting bolts (D) in a crisscross pattern in several steps, then remove the pressure plate (E).
4. Inspect the fingers of the diaphragm spring (A) for wear at the release bearing contact area.
