Fit L4-1.5L (2008)
2. Install the new pilot bearing (A) into the crankshaft using the driver (B) and the 28 x 30 mm attachment (C). Apply a light coat of oil to the bearing
surface.
Flywheel Inspection
1. Inspect the ring gear teeth for wear and damage.
2. Inspect the clutch disc mating surface on the flywheel for wear, cracks and burning.
3. Measure the flywheel (A) runout using a dial indicator (B) through at least two full turns with the engine installed. Push against the flywheel each
time you turn it to take up the crankshaft thrust washer clearance. If the runout is more than the service limit, replace the flywheel and recheck the
runout. Resurfacing the flywheel is not recommended.
Flywheel Replacement
