Fit L4-1.5L (2008)
5. Torque the mounting bolts in a crisscross pattern. Tighten the bolts in several steps to prevent warping the diaphragm spring.
6. Remove the clutch alignment tool set and ring gear holder.
7. Make sure the diaphragm spring fingers are all the same height.
Release Bearing Replacement
1. Remove the release fork boot (A) from the clutch housing (B).
2. Remove the release fork (C) from the clutch housing by squeezing the release fork set spring (D) with pliers. Remove the release bearing (E).
3. Check the play of the release bearing by spinning it by your hand. If there is excessive play or noise, replace the release bearing with a new one.
NOTE: The release bearing is packed with grease. Do not wash it in solvent.
