Fit L4-1.5L (2008)
Pressure Regulating Solenoid: Testing and Inspection
A/T Clutch Pressure Control Solenoid Valve B Test
A/T Clutch Pressure Control Solenoid Valve B Test
1. Connect the HDS to the DLC (A).
2. Select Clutch Pressure Control (Linear) Solenoid B in the Miscellaneous Test Menu with the HDS.
NOTE: If the HDS does not communicate with the PCM, troubleshoot the DLC circuit.
3. Test A/T clutch pressure control solenoid valve B with the HDS.
^
If the valve tests OK, the test is complete. Disconnect the HDS.
^
If the valve does not test OK, follow the instructions on the HDS.
^
If the valve does not test OK, and the HDS does not determine the cause, go to step 4.
4. Remove the air cleaner assembly.
5. Disconnect the A/T clutch pressure control solenoid valve B connector.
6. Measure the A/T clutch pressure control solenoid valve B resistance at the connector terminals.
Standard: 3 - 10 ohms
^
If the resistance is out of standard, replace A/T clutch pressure control solenoid valve B.
^
If the resistance is within the standard, go to step 7.
7. Connect a jumper wire from the negative battery terminal to solenoid valve B connector terminal No. 2, and connect another jumper wire from the
positive battery terminal to connector terminal No. 1.
^
If a clicking sound is heard, the valve is OK. Reconnect the connector, and install all removed parts.
^
If no clicking sound is heard, go to step 8.
8. Disconnect the A/T clutch pressure control solenoid valve C connector, remove the breather tube from the radiator upper hose bracket and remove
the radiator upper hose bracket (A), then remove A/T clutch pressure control solenoid valves B and C.