Fit L4-1.5L (2008)
9. Disconnect the connectors, remove the shift solenoid harness connector (E), and replace it.
10. Install the new O-ring (F) on the new shift solenoid harness connector, and install the connector in the transmission housing.
11. Connect the WHT and ORN wires connector to shift solenoid valve B. The ATF temperature sensor is assembled in the WHT wires connector.
12. Connect the harness terminals to the solenoids:
^
BLU wire connector to shift solenoid valve A.
^
GRN wire connector to shift solenoid valve C.
^
YEL wire connector to shift solenoid valve D.
13. Install the shift solenoid valve cover, dowel pins, and a new gasket.
14. Check the connector for rust, dirt, or oil, then connect it securely.
15. Refill the transmission with ATF.
16. Install the splash shield.
