Fit L4-1.5L (2008)
13. Use a suction cup to hold the front corner glass (A) over the opening while holding the front corner trim (B) with the other hand, align the clips,
and set it down on the adhesive. Lightly push on the front corner glass until its edges are fully seated on the adhesive all the way around.
NOTE: Do not open or close any of the doors for about an hour until the adhesive is dry.
14. Scrape or wipe the excess adhesive off with a putty knife or towel. To remove adhesive from a painted surface or the front corner glass, wipe with
a soft shop towel dampened with alcohol.
15. After the adhesive has dried, spray water over the front corner glass and check for leaks. Mark the leaking areas and let the front corner glass dry,
then seal with sealant. Let the vehicle stand for at least 4 hours after front corner glass installation. If the vehicle has to be used within the first 4
hours, it must be driven slowly.
16. Reinstall all remaining removed parts.
NOTE: Advise the customer not to do the following things for 2 to 3 days:
-
Slam the doors with all the windows rolled up.
-
Twist the body excessively (such as when going in and out of driveways at an angle or driving over rough, uneven roads).
