Fit L4-1.5L (2008)
3.
Carefully remove the small rubber grommet below the nozzle, and remove the large rubber grommet below the high mount brake light.
4.
Disconnect the washer hose and the plastic hose joint from the large grommet.
5.
Pull the hose up and out through the small grommet opening in the tailgate.
6.
Disconnect the hose from the washer nozzle hose section, and discard it.
7.
Using the new parts in the kit, assemble the washer hose and check valve. The arrow on the check valve points towards the nozzle.
8.
Attach the new hose to the washer nozzle hose section.
9.
Feed the check valve end of the new hose into the small grommet opening and out through the large grommet opening.
10.
Attach the washer hose check valve to the large grommet, then reinstall the grommet.
11.
Attach the washer hose to the nozzle, and reinstall the small grommet.
12.
Test the rear washer for proper operation. If the spray pattern is not within the standard area, adjust the nozzle:
^
Refer to page 22-136 of the 2007-2008 Fit Service Manual, or
^
Online enter keywords NOZ ADJ, then select Wiper Arm/Washer Nozzle Adjustment from the list.
Disclaimer
