Insight L4-1.3L Hybrid (2010)
9. Unclip the 3P connector, and disconnect it from the LED array wire harness using a small, flat-tip screwdriver.
10. Carry the disconnected taillight assembly to a workbench, placing a clean shop towel beneath it to prevent the lens from being scratched or
damaged.
11. Use scissors to cut about 2.25 inches of the 3M strip caulk or the 3M ribbon sealer.
NOTE:
Either material may be used.
12. Apply the strip caulk or ribbon sealer to the taillight and around the LED array grommet.
