Odyssey L4-2.2L SOHC (1995)
-
Before removing the steering column, first disconnect the connector between the cable reel and the SRS main harness.
-
If the steering column is going to be removed with-out dismounting the steering wheel, lock the steering by turning the ignition key to 0-LOCK
position, or remove the key from the ignition so that the steering wheel will not turn.
NOTE: When the airbag assembly and cable reel are disconnected, and the battery is reconnected and the ignition switch is turned ON (II), the SRS unit
will store this as an open in the driver's airbag inflator, and the SRS indicator light will come on. In such a case, make sure to confirm the DTC, and to
troubleshoot it.
Do not replace the original steering wheel with any other design, since it will make it impossible to properly install the airbag (use only genuine Honda
replacement parts).
After reassembly, confirm that the wheels are still turned straight ahead and that the steering wheel spoke angle is correct. If minor spoke angle
adjustment is necessary, do so only by adjustment of the tie-rods, not by removing and repositioning the steering wheel.
