Odyssey L4-2.2L SOHC (1995)
Fig. 17 Spring Piston Into Caliper Installation
7. Install sleeve piston with hole in bottom of piston aligned with rod, and two pins on piston aligned with holes in caliper, Fig. 17.
8. Install new cup with its groove facing toward bearing A side of adjusting bolt.
9. Fit bearing A, spacer, adjusting spring B and spring cover on adjusting bolt, then install assembly into caliper cylinder.
10. Install brake spring compressor, then compress spring until it bottoms out.
11. Ensure flared end of spring cover is below circlip groove, then install circlip and remove compressor.
12. Install adjusting nut, adjusting spring A and washer in piston, then secure with circlip.
13. Coat new piston seal and piston boot with silicone grease, then install into caliper.
14. Coat outside of piston with silicone grease, then install it onto adjusting bolt while rotating it clockwise. Be careful not to damage piston boot.
15. Install pad spring into caliper housing.
16. Install caliper assembly.
