Odyssey L4-2.2L SOHC (1995)
-
In the first step, tighten all bolts in sequence to about 29 Nm (22 ft. lbs.).
-
In the final step, tighten in the same sequence to 74 Nm (54 ft. lbs.).
NOTE: Coat the bolt threads with engine oil.
CAUTION: Whenever any crankshaft bearing or connecting rod bearing is replaced, it is necessary after reassembly to run the engine at idling
speed until it reaches normal operating temperature, then continue to run it for approximately 15 minutes.
9. Apply liquid gasket to the block mating surface of the right side cover, then install it on the cylinder block.
NOTE:
^
Use liquid gasket, part No. 08718 - 0001.
^
Check that the mating surfaces are clean and dry before applying liquid gasket.
^
Apply liquid gasket evenly, being careful to cover all the mating surface.
^
To prevent oil leakage, apply liquid gasket to the inner threads of the bolt holes.
^
Do not install the parts if 5 minutes or more have elapsed since applying the liquid gasket.
Instead, reapply liquid gasket after removing the old residue.
^
After assembly, wait at least 20 minutes before filling the engine with oil.
