Odyssey V6-3.5L (2003)
Power Sliding Door Module: Testing and Inspection
Power Sliding Doors
Control Unit Input Test
Left Power Sliding Door Control Unit:
1. Remove the left rear side trim panel.
2. Remove the left power sliding door control unit.
3. Disconnect the 26P connector (A) and 5P connector (B) from the left power sliding door control unit (C).
4. Inspect the all connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 5.
