Odyssey V6-3.5L (2003)
Impact Sensor: Service and Repair
Side Impact Sensor
Side Impact Sensor Replacement
Removal
NOTE:
-
Removal of the side impact sensor must be performed according to the precautions/procedures described at the beginning of this section.
-
Before disconnecting the side impact sensor 2P connector(s), disconnect the side airbag 2P connector(s).
-
Do not turn the ignition switch ON (II), and do not connect the battery cable while replacing the side impact sensor.
1. Disconnect the negative battery cable, and wait at least 3 minutes before beginning work.
2. Remove the seat assembly.
3. Remove the left rear side trim panel.
4. Remove the center pillar lower trim panel.
5. Disconnect the side wire harness 2P connector (A) from the side impact sensor (B).
6. Remove the Torx bolts (C) using a Torx T30 bit, then remove the side impact sensor.
Installation
NOTE:
-
Be sure to install the harness wires so they are not pinched or interfering with other parts.
-
Do not turn the ignition switch ON (II), and do not connect the battery cable while replacing the side impact sensor.
1. Install the new side impact sensor with the Torx bolts (A) then connect the side wire harness 2P connector (B) to the side impact sensor (C).
2. Reconnect the battery negative cable.
3. After installing the side impact sensor, confirm proper system operation: Turn the ignition switch ON (II): the SRS indicator should come on for
about 6 seconds and then go off.
4. Install all removed parts.
