Odyssey EX L4-2253cc 2.3L SOHC (VTEC) MFI (1998)
_mfi/Page-1442003.png)
WARNING:
^
Never use an air hose or dry brush to clean brake assemblies.
^
Use an OSHA-approved vacuum cleaner to avoid breathing brake dust.
^
Contaminated brake discs or pads reduce stopping ability.
^
When reusing the pads, always reinstall the brake pads in their original positions to prevent loss of braking efficiency.
CAUTION:
^
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
^
Clean all parts in brake fluid and air dry; blow out all passages with compressed air.
^
Before reassembling, check that all parts are free of dust and other foreign particles.
^
Replace parts with new ones whenever specified to do so.
^
Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.
^
Always use Genuine Honda DOT 3 Brake Fluid. Using a non-Honda brake fluid can cause corrosion and decrease the life of the system.
^
Replace all rubber carts with new ones whenever disassembled.
1. Clean the piston and caliper bore with brake fluid, and inspect for wear and damage.
