Odyssey EX L4-2253cc 2.3L SOHC (VTEC) MFI (1998)
_mfi/Page-1607007.png)
14. Coat the flow control valve with power steering fluid.
15. Install the flow control valve and spring on the pump housing.
16. Coat the O-ring with power steering fluid, and install it on the flow control valve cap.
17. Install the flow control valve cap on the pump housing, and tighten it.
18. Coat the O-ring with power steering fluid, and install it into the grooves in the inlet joint.
19. Install the inlet joint on the pump housing, and tighten the flange bolt.
20. Install the pulley as shown below, then loosely install the pulley nut. Hold the steering pump in a vise with soft jaws.
CAUTION: Be careful not to damage the pump housing with the jaws of the vise.
