Odyssey EX L4-2253cc 2.3L SOHC (VTEC) MFI (1998)
_mfi/Page-1297005.png)
6. Remove the circlip.
7. Mark the spider and driveshaft to identify the position of the spider on the shaft.
8. Remove the spider using a commercially-available bearing remover.
9. Wrap the splines on the driveshaft with vinyl tape to prevent damage to the boots.
10. Remove the inboard boot and outboard boot, then remove the vinyl tape.
CAUTION: Take care not to damage the boot.
11. Inspect the outboard joint for faulty movement and wear. If any roughness or excess play is felt, replace the outboard joint.
REASSEMBLY
