Odyssey EX V6-3.5L (1999)
Is there at least 6 V available to the closer motor when the door reaches the half-latched position?
Yes - Go to step 23.
No - Go to step 14. **
14.
Open the affected sliding door, and remove the B-pillar trim and the front seat belt retractor (see section 23 of the 1999-02 Odyssey Service
Manual for SRS precautions).
15.
Backprobe terminal No. 1 and terminal No. 2 of the junction switch connector.
16.
** Close the sliding door with the dashboard door switch, and watch the voltage reading as the door closes. **
Is battery voltage available when the door reaches the half-latched position?
** Yes - Check terminals No. 1 and No. 2 of the junction switch connector for a poor fit. If the fit is OK, replace both sides of the junction switch,
and adjust them (see S/B 99-072, Sliding Door Alarm Beeps, filed under Body Electrical, for replacement and alignment procedures). **
No - Go to step 17.
17.
** Remove the power sliding door control unit (see page 22-298 of the 1999-02 Odyssey Service Manual). **
18.
Unplug power sliding door control unit connector A (26P) from the power sliding door control unit. Unplug the junction switch connector at the
affected sliding door.