Odyssey EX V6-3.5L (1999)
4.
Install the new seat riser onto the slide adjusters. Apply a small amount of Honda 2 Threadlock to the stud threads, and install the flange nuts onto
the studs. Torque the flange nuts to 21 N.m (15 lb-ft).
5.
Reinstall the seat riser covers.
6.
Reinstall the seat.
7.
Make sure the seat properly locks into position. If the seat is difficult to lock, remove the striker cover (one screw), remove the rubber strip under
the striker cover, and reinstall the striker cover.
8.
Repeat steps 1 through 7 for the other bucket seat.
9.
Check the VIN.
^
If the VIN is from 2HKRL18..XH502919 thru 2HKRL18..XH526889, go to step 19.
^
If the VIN is thru 2HKRL18..XH502918, go to step 10.
10.
Remove the inside pivot cover from one of the second row bucket seats.
11.
Remove the pivot bolt.
12.
Remove the plastic collar from the pivot bracket.
13.
Apply a 6 x 15 mm piece of electrical tape to the plastic collar.
14.
Reinstall the plastic collar.
15.
Reinstall the pivot bolt. Torque the bolt to 21 N.m (15 lb-ft).
16.
Reinstall the inside pivot cover.
