honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Body - Power Sliding Door Won't Close Completely|Page 11233 > < Body - Power Sliding Door Won't Close Completely
Page 2
background image

Out of warranty: 
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager or your Zone Office. You
must request consideration, and get a decision, before starting work.

REPAIR PROCEDURE

1.

Make sure all recalls for the vehicle have been completed (see S/B 99-054, Safety Recall: Odyssey Sliding Doors, and S/B 00-047, Safety Recall:
Rear Door Latch Assembly; filed under Body).

2.

** Align the affected sliding door, then align the junction switch (see S/B 99-072, Sliding Door Alarm Beeps, filed under Body Electrical). **

3.

Test-drive the vehicle on a rough road, then test the affected sliding door by opening and closing it several times.

Does the door close completely?

** Yes - Return the vehicle to your customer. **

No - Go to step 4.

4.

** With the door fully closed, press the OPEN side of the dashboard door switch for the affected door. Does the door open normally?

Yes - Go to step 5. 

No - Left door: Inspect the No. 1 (20A) fuse in the passenger's under-dash fuse/relay box. If the fuse is OK, repair the open in the GRN wire
between the driver's under-dash fuse/relay box and the power sliding door control unit.

Right door: Inspect the No. 5 (20A) fuse in the passenger's under-dash fuse/relay box. If the fuse is OK, repair the open in the RED/YEL wire
between the passenger's under-dash fuse/relay box and the power sliding door control unit.

5.

Close the sliding door with the dashboard door switch. As it reaches the half-latched position, listen to the sliding door alarm.

Does the alarm beep five times as the door reaches the B-pillar?

Yes - Go to step 6. **

No-Go to step 11.

6.

With the affected sliding door open, measure the voltage to body ground at terminal D of the body-side junction switch.

Is there 10 V or more?

** Yes - Go to step 7.

No - Repair the open in the YEL/GRN wire between the power sliding door control unit and the junction switch. **

7.

Remove the B-pillar trim and the front seat belt retractor (see section 23 of the 1999-02 Odyssey Service Manual for SRS precautions).

Body - Power Sliding Door Won't Close Completely|Page 11233 > < Body - Power Sliding Door Won't Close Completely