Odyssey EX V6-3.5L (1999)
Vacuum Brake Booster: Service and Repair
Brake Booster Replacement
1. Remove the master cylinder.
2. Remove the intake air duct (A)
3. Remove the cable bracket (B) from the throttle body, then disconnect the throttle cable end (C) and actuator cable end (D) from the throttle
linkage.
4. Disconnect the vacuum hose (E) from the brake booster (F).
5. Remove the lock pin (A) and joint pin (B).
6. Remove the four booster mounting nuts (C).
7. Pull the brake booster (A) forward, and remove it from the engine compartment.
8. Install the brake booster in the reverse order of removal, and note these items:
-
After installation, adjust brake pedal height and brake pedal free play.
-
After installation, check the throttle cable free play, and adjust the actuator cable or the throttle cable if necessary.