Odyssey EX V6-3.5L (1999)
4. Measure the resistance between the No.1 and No.5 terminals of the rear blower resistor.
Is there approximately-3 ohm ?
YES-Go to step 5.
NO-Replace the rear blower resistor.
5. Check for continuity between the No.5 terminal of the rear blower resistor 5P connector and the No.2 terminal of the rear blower motor lower
relay 5P socket.
Is there continuity?
YES-Go to step 6.
NO-Repair open in the wire between the rear blower resistor and the rear blower motor low relay.
6. Check for continuity between the No.1 terminal of the rear blower motor low relay 5P socket and body ground.
Is there continuity?
YES-Go to step 7.
NO-Check for an open in the wire between the rear blower motor low relay and body ground.If the wire is OK, check for poor ground at G 582.
7. Turn the ignition switch ON (II).