honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Symptom Related Diagnostic Procedures|Page 3023 > < Symptom Related Diagnostic Procedures|Page 3021
Page 6
background image

4. Measure the voltage between the No.2 terminal of the A/C diode C 2P connector and body ground.

Is there battery voltage?

YES-Go to step 5.

NO-Repair open in the wire between the radiator fan relay and the A/C diode C.

5. Turn the ignition switch OFF.
6. Reinstall the A/C diode C.
7. Disconnect the A/C pressure switch 4P connector.
8. Turn the ignition switch ON (II).

9. Measure the voltage between the No.2 terminal of the A/C pressure switch 4P connector and body ground.

Is there battery voltage?

YES-Go to step 10.

NO-Repair open in the wire between the A/C diode C and the A/C pressure switch.

10. Turn the ignition switch OFF

11. Check for continuity between the No.1 and No.3 terminals of the A/C pressure switch 4P connector.

Is there continuity? 

YES-Replace the A/C pressure switch.

NO-Repair open in the wire between the A/C pressure switch A and B.

Low Speed Circuit

1. Check the No.58 (30 A) fuse in the under-hood fuse/relay box, and the No.3 (7.5 A) fuse in the driver's under-dash fuse/relay box.

Are the fuses OK?

YES-Go to step 2.

NO-Replace the fuse(s), and recheck.

Symptom Related Diagnostic Procedures|Page 3023 > < Symptom Related Diagnostic Procedures|Page 3021