honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Air Mix Control Motor|Page 8324 > < Air Mix Control Motor|Page 8322
Page 12
background image

13. Check for continuity between the No.23 and No.24 terminals of climate control unit connector B (26P) and body ground individually.

Is there continuity?

YES - Repair any short to body ground in the wire (s) between the climate control unit and the recirculation control motor.

NO - Go to step 14.

14. Turn the ignition switch ON (II), and check the same terminals for voltage.

Is there any voltage?

YES - Repair any short to power in the wire between the climate control unit and the recirculation control motor. This short may also damage the
climate control unit. Repair the short to power before replacing the climate control unit.

NO - Go to step 15.

15. Turn the ignition switch OFF.

16. Check for continuity between the following terminals of climate control unit connector B (26P) and the recirculation control motor 7P connector.

26P:    7P:
No.23    No.5
No.24    No.7

Is there continuity?

YES - Check for loose wires or poor connections at climate control unit connector B (26P) and at the recirculation control motor 7P connector. If
the connections are good, substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original

Air Mix Control Motor|Page 8324 > < Air Mix Control Motor|Page 8322