honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Symptom Related Diagnostic Procedures|Page 8724 > < Symptom Related Diagnostic Procedures|Page 8722
Page 3
background image

13. Disconnect the rear A/C control dial 10P connector.

14. Check for continuity between the No.8 terminal of the rear heater-A/C main switch 10P connector and body ground.

Is there continuity?

YES-Test the rear heater-A/C main switch  and the rear heater-A/C passenger 5 control panel.

NO-Check for an open in the wire between the rear heater-A/C main switch and body ground. If the wire is OK, check for poor ground at G401.

15. Disconnect the jumper wire.

16. Disconnect the rear blower motor 2P connector.

17. Measure the voltage between the No.1 terminal of the rear blower motor 2P connector and body ground.

Is there battery voltage?

YES-Replace the rear blower motor.

NO-Repair open in the wire between the No.60 fuse in the multi4uselrelay box and the rear blower motor.

Rear Blower Motor Low Speed Circuit Troubleshooting

1. Remove the rear blower unit.

2. Remove the rear blower motor low relay, and test it.

Is the relay OK?

YES-Go to step 3.

NO-Replace the rear blower motor low relay.

3. Disconnect the rear blower resistor.

Symptom Related Diagnostic Procedures|Page 8724 > < Symptom Related Diagnostic Procedures|Page 8722