Odyssey EX V6-3.5L (1999)
^
If the door does not fit tightly, go to step 28.
^
If the door fits tightly, go to step 29.
28.
Loosen the three lower roller bolts, and move the door up or down to align the body lines and to provide good junction switch contact. Loosen the
lower roller bottom nut to adjust the door in or out until the door is held tightly against the seals. When you're finished with this adjustment, torque
the three top bolts on the roller to 22 Nm (16 lb-ft); torque the bottom bolt to 10 N.m (7 lb-ft).
NOTE:
For best junction switch contact, make sure there is minimal in and out movement at the front of the door while keeping the door flush to the body.
29.
Remove the weatherstrip from the rear edge of the door opening.
30.
Turn on the power sliding door main switch.
