Odyssey EX V6-3.5L (1999)
Fuel Gauge Sender: Testing and Inspection
Fuel Gauge Sending Unit Test/Replacement
Special Tools Required
Fuel tank assembly wrench 07XAA-001010A
1. Remove the rear seats and carpet.
2. Remove the access panel from the floor.
3. Turn the ignition switch OFF, then disconnect the fuel tank unit 5P connector.
4. Remove the fuel fill cap.
5. Relieve the fuel pressure.
6. Disconnect the quick-connect fittings from the fuel tank unit.
7. Using the tool, loosen the fuel tank unit locknut (A).
8. Measure the resistance between the No.1 and No.2 terminals with the float at E (EMPTY), 1/2 (HALF FULL), and F (FULL) positions.
If you do not get the following readings, replace the fuel gauge sending unit (A).
