Odyssey EX V6-3.5L (1999)
69.
Backprobe terminal No. 6 (GRN/BLK, right door) or terminal No. 9 (GRN/BLK, left door) of the control unit 26P connector. Then, while you
monitor voltage to ground, have an assistant test-drive the vehicle under the same conditions as in step 1.
Is there ever more than 1 V?
YES - Repair the open or high resistance in the wire between the junction switch connector and the control unit. Then go to step 72.
NO - Go to step 70.
70.
Inspect the terminals in the control unit connector. If any are loose or damaged, replace them (see Service Bulletin 00-099, Terminal Replacement
Instructions, filed under Tools).
71.
Test-drive the vehicle under the same conditions as in step 1.
^
If the sliding door alarm no longer beeps, go to step 72.
^
If the alarm still beeps, replace the sliding door control unit. Then go to step 72.
72.
Confirm that the sliding doors work correctly by opening and closing them several times with the dashboard door switches, the remote transmitter,
and the sliding door handles.
73.
Install all removed trim panels, and replace any damaged clips.
74.
Enter the anti-theft code(s) and the radio station presets. Set the clock.
DISCLAIMER
