Odyssey EX V6-3.5L (1999)
14. Look in the following tables for the switch most closely related to the problem. While still in Mode 2, operate that switch to test the circuit
between the switch and its control unit. If the circuit is OK, the ignition key light should blink once and the beeper should beep once. If the circuit
is faulty, there will be no indication.
Does the ignition key light blink and beeper beep?
YES-The circuit is OK. Refer to the test(s) for that individual system.
NO-Go to step 15.
In each table below, the control unit is followed by a list of circuits that it can check in Mode 2.
15. Check two or three more circuits listed for that control unit.
Does the ignition key light blink and the beeper beep for each circuit?
YES-The additional circuits are OK. Repair the short or open in the circuit that failed the test in the preceding step.
NO-Multiple failed circuits can mean that the control unit has failed, but without triggering a DTC. Test a few more circuits. If they also fail,
substitute a known-good control unit, then recheck. If the system works properly, the original control unit is faulty; replace it. If there is still a
malfunction, substitute a known-good control unit for the next most likely faulty control unit, then recheck. If the system works properly, that
control unit is faulty; replace it.
Multiplex Control Unit Input Test
Door Unit:
