Odyssey EX V6-3.5L (1999)
clips.
NOTE:
If any wires on the new switch are touching each other, separate them.
9.
Remove the center pillar lower trim panel (see page 20-56 of the service manual).
10.
Remove the front seat belt retractor, but keep the tensioner connector connected (see page 23-4 of the service manual).
11.
Inside the B-pillar, disconnect the body junction switch from its electrical connector, and unclip its wire clips.
12.
Remove the body junction switch (two screws).
13.
Install the new body junction switch in the reverse order of removal, making sure to connect its connector and to route its wires with the wire clips.
NOTE:
If any wires on the new switch are touching each other, separate them.
14.
Open the sliding door, then turn off the power sliding door main switch on the dashboard.