Odyssey EX V6-3.5L (1999)
36.
Mark each pin on the body junction switch with a dry-erase marker. (Dry-erase markers are commonly used on whiteboards.)
37.
Close the door, then open it.
38.
Inspect the pin contact points on the body junction switch. You should see a small spot where each door pin wiped an area clean on each body pin.
^
If the spots are centered on every pin, go to step 39.
^
If the spots are not centered, loosen the screws on the door junction switch, then move the switch to align the contact points. When you're
finished with this adjustment, tighten the switch screws, then go to step 39.
NOTE:
If you can't align the pins, adjust the door up or down by repeating steps 25 thru 35 as needed.
39.
Wipe the door and body junction switch pins with a clean, dry shop towel, then clean each pin by wiping it with a pencil eraser.
NOTE:
Never use sandpaper or other abrasives to clean the pins.
40.
Do the switch check, door adjustment, and switch alignment procedures on the other sliding door. Repeat steps 4 through 39, as needed.
41.
Write down the radio station presets.
42.
Disconnect the negative cable from the battery.
NOTICE
If you don't disconnect the negative cable, you'll damage the power sliding door control units.
43.
If not already done, remove the left and right center pillar lower trim panels (see page 20-56 of the 1999-01 Odyssey Service Manual).
44.
Check whether the ground bolts at G551 and G581 have star washers between the ground terminal and the body.
