Odyssey EX V6-3.5L (1999)
Malfunction Lamp / Indicator: Testing and Inspection
SRS Light Stays on After the Ignition Switch Is Turned on (II)
When the ignition key is turned to the ON (II) position, the SRS control unit performs a self-test that takes about six seconds. During the self-test, there
is not any voltage from the control unit going to the SRS indicator circuit. This turns the indicator light on. If the self-test is OK, the control unit will
send approximately 8.5 V to the SRS indicator circuit. This turns the indicator light off.
The SRS Indicator Light Stays On After the Ignition Switch is Turned
ON (II).
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator light comes on for about six seconds and then goes off.
Does the SRS indicator light stay on?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures.
3. Turn the ignition switch OFF.
4. Check for blown No.2 (10 A) fuse in the driver's under-dash fuse/relay box.
Is the fuse OK?
YES - Go to step 8.
NO - Go to step 5.
5. Replace the No.2 (10 A) fuse.
6. Erase the DTC memory.
7. Turn the ignition switch ON (II).
Does the SRS indicator light go off after six seconds?
YES - The system is OK.
NO - Confirm the DTC, and continue troubleshooting.
8. Disconnect the battery negative cable, and wait for three minutes.
