Odyssey EX V6-3.5L (1999)
Installation
1. Install the retractor mounting bolt (A), then install the new seat belt.
2. Reinstall the upper anchor bolt (A) and upper anchor cover (B).
3. Reconnect the seat belt tensioner 2P connector (A) to the side wire harness 2P connector (B).
4. Reinstall the center pillar lower trim panel.
5. Reconnect the negative battery cable.
6. After installing the seat belt, confirm proper system operation. Turn the ignition switch ON (II); the SRS indicator light should come on for about
six seconds and then go off.
