Odyssey EX V6-3.5L (1999)
17. Check resistance between the No.4 terminal and the No.11 terminal of the SRS main harness 18P connector. There should be 1 M ohm or more.
Is the resistance as specified?
YES - Faulty SRS unit; replace the SRS unit.
NO - Short in SRS main harness; replace the SRS main harness.
3-4 Short to Power In Driver's Seat Belt Tensioner
DTC 3-4: Short to power in driver's seat belt tensioner
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator light comes on for about six seconds and then goes off.
Does the SRS indicator light stay on?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures.
3. Disconnect the battery negative cable, and wait for three minutes.
4. Disconnect the driver's seat belt tensioner 2P connector from the left side wire harness 2P connector (A).
5. Connect the special tool (2 ohms) to the left side wire harness 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is DTC 3-4 indicated?
YES - Go to step 9.
