Odyssey EX V6-3.5L (1999)
Evaporator Temperature Sensor / Switch: Description and Operation
Voltage is provided at all times to the heater control panel through fuse 13, and to the A/C compressor clutch relay contacts through fuse 59. With the
ignition switch ON (II), voltage is supplied to the control unit and the relay coil through fuse 3. The control panel is grounded at G401.
When you push the A/C button ON with the ignition switch ON (II) and the heater fan switch not in the OFF position, the control panel will ground the
A/C ON input of the PCM through the A/C pressure switch. The PCM then grounds the coil in the A/C compressor clutch relay. This energizes the coil,
which closes the relay contacts and provides voltage through fuse 59 to the compressor clutch. The clutch then engages and begins turning the
compressor.
The evaporator temperature sensor is located on the evaporator housing. If the temperature at the evaporator gets too cold, the evaporator temperature
sensor sends a signal to the heater control panel to turn off the A/C compressor clutch. This prevents condensation from freezing on the evaporator fins
and blocking air delivery into the passenger compartment.
