Odyssey EX V6-3.5L (1999)
13.
At the left D-pillar, locate and remove the ground bolt for G552.
14.
Use sandpaper to remove the paint around the ground bolt hole.
*15. Clean the paint out of the ground bolt hole by running a 6 mm x 1.0 tap through the hole.*
16.
Put a star washer between the ground terminal and the body. Reinstall the ground bolt, and torque the ground bolt to 9 Nm (7 lb-ft).
17.
At the right D-pillar, locate and remove the ground bolt for G582.
18.
Repeat steps 14 thru 16 at G582.
19.
Reinstall the left and right D-pillar trim pieces. Make sure the rear seat belts retract smoothly.
20.
Reconnect the negative cable to the battery.
21.
Reset the clock, enter the anti-theft code(s), and enter the radio station presets.
22.
Clear the DTCs from the power sliding door control units. Refer to page 22-243 of the 1999-00 Odyssey Service Manual.
23.
Close the power sliding door.
24.
Turn the power sliding door main switch OFF.
25.
Slowly open the power sliding door manually. Open the door all the way.
26.
Turn the power sliding door main switch ON.
27.
Press and hold the power sliding door switch to close the door you just opened manually. Continue to hold the switch until the door is closed.
28.
Do steps 23 thru 27 on the other sliding door.
29.
Open and close both sliding doors using the dash switches, the inner and outer door handles, and the key less entry remote transmitters.
Disclaimer
