Odyssey EX V6-3.5L (1999)
18.
Close the sliding door fully, then inspect the gaps at the front and rear of the door. Also inspect the top to bottom position of the rear of the door,
using the center body line as a reference.
NOTE:
For best junction switch contact, make the gap at the front of the door smaller than the rear gap. But don't make the front gap smaller than 4.5 mm or
the rear gap larger than 8.5 mm.
19.
Support the door, then loosen the center roller bolts.
20.
To equalize the gaps between the door and the body, move the door forward or backward and up or down while keeping the center roller level.
When you're finished with this adjustment, torque the center roller bolts to 22 Nm (16 lb-ft).
