Odyssey EX V6-3.5L (1999)
3. Lower the rear suspension. Position the lower arm (A), and loosely install the flange bolt (B) and self locking nut (C).
4. Position a floor jack at the connecting point of the lower arm and the knuckle.
5. Align the bolt hole with the holes in the lower arm and the knuckle by raising the flange bolt.
6. Raise the rear suspension with a floor jack until the vehicle just lifts off the safety stand.
7. Tighten the self-locking nut.
8. Tighten the flange bolt.
9. Install the wheel sensor.
10. Install the rear wheel.
11. Check the rear wheel alignment, and adjust it if necessary.
