Odyssey LX V6-3.5L (2000)
3. Disconnect and detach the connectors (A), and for '03-04 models driver's door, detach the connectors from the door harness bracket (B). Detach
the harness clip (C) from the door. Remove the bolts (D) and loosen the bolts (E), then remove the regulator (F) through the hole in the door.
4. Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.
5. Install the glass and regulator in the reverse order of removal, and note these items:
-Roll the glass up and down to see if it moves freely without binding.
-
Make sure that there is no clearance between the glass and glass run channel when the glass is closed.
-
Adjust the position of the glass as necessary.
-
Check for water leaks.
-
For '03-04 models: Reset the power window control unit.
-
Test-drive and check for wind noise and rattles.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its perimeter.
