Odyssey LX V6-3.5L (2000)
6. Reconnect the connectors to the left sliding door control unit and, with the master switch off, perform these input tests at the connectors.
-
If any test indicates a problem, find and correct the cause, then recheck the system
-
If all the input tests prove OK, the control unit must be faulty, replace it.
Right Power Sliding Door Control Unit:
1. Remove the right rear side trim panel.
2. Remove the right power sliding door control unit.
3. Disconnect the 26P connector (A) and 5P connector (B) from the right power sliding door control unit (C).
4. Inspect the all connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 5.
