Odyssey LX V6-3.5L (2000)
-2 Remove the damper housing.
-
Center punch around the spot weld imprints on the front side frame, lower dashboard, and dashboard upper.
-
Drill holes using a spot cutter.
-
Using a chisel, pry off the weld flange.
-
From the passenger compartment side, drill holes in the spot welded area with a 5 mm (0.2 in.) spot weld cutter.
NOTE: Drill holes completely through the parts since the replacement damper housing will be welded by MIG welding.
6. Straighten the related parts.
-
Level and finish the burrs left on the welding surfaces with a sander.
-
Fill all drilled holes by MIG or gas welding.
-
Use a hammer and dolly to even out the welded areas of the lower dashboard, front side frame and dashboard upper side member.