Odyssey LX V6-3.5L (2000)
Roof Rack Frame: Service and Repair
Roof Rail Replacement
NOTE:
-
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
-
Take care not to scratch the covers, roof rail and body.
1. Remove the front cover (A) and rear cover (B) by sliding them in the direction shown while pushing the spring plate (C) through the hole on each
bracket with a flat-tip screwdriver. Remove the center cap (D), then with a Torx T30 bit, remove the nuts (F) from the front bracket (G) and rear
bracket (H).
2. Remove the roof rail (I). Do not remove the rubber pads from the brackets.
3. Remove the center cover (J). Using a Torx T30 bit, remove the nuts (E, F) and the center bracket (K). Do not remove the rubber pad from the
center bracket.
4. Install the roof rail in the reverse order of removal. Make sure the front and rear covers are snapped tightly into place.
